There is no guarantee that interference will not occur in a particular installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. These limits are designed to provide reasonable protection against harmful interference in residential installations. This equipment has been tested and found to comply with the limits for a Class B Digital device, pursuant to part 15 of the FCC rules. Never connect an amplifier to amp in simultaneously with an instrument to instrument in! This could lead to an electric shock and also break your precious equipment! From here the signal is passed through to the XLR output and via the blend and volume controls to the headphone outputs. You can now choose the impulse response from slots 1-5 or the bypass signal. Use the input labelled “ Amp In” on the Element. If you are using a Darkglass amplifier with a class D poweramp you have the option to connect the amplifier straight to the Element without using a speaker cabinet or an external load. Use the input labelled “ Amp In” for the amplifier and the output labelled “ Speaker Out” to connect the speaker cabinet to the Element. In case the amplifier’s output is maximum 100 Watts, the Element can be connected between the amplifier and the speaker cabinet. For the safest operation it is advised to connect the Element after your speaker cabinet from your speaker cabinet’s parallel output connector. The Element is built to work with amplifiers with a maximum output of 900 Watts. Note: The Element does NOT act as a loadbox! Always make sure your amplifier is connected to a suitable load! From here the signal is passed through to the XLR output and via the blend and volume controls to the headphone outputs.Įlement with your amplifier and speaker cabinet Use the input labelled “ Instrument In” on the Element You can now choose the impulse response from slots 1-5 or the bypass signal. Connect your instrument to your pedalboard as you normally would and add the Element at the end of the signal chain.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |